Difference between revisions of "Groove Mounting Plates"

From E3D-Online
Jump to: navigation, search
This Wiki is not looked after anymore :( Please navigate to
e3d-online.dozuki.com
for up to date and improved documentation
(Grove Mounting Plates)
Line 1: Line 1:
 
=== Grove Mounting Plates ===
 
=== Grove Mounting Plates ===
  
 +
[[File:Groove_Mounting_Plates.png|thumb|left|E3D Groove Mounting Plate]]
 +
 +
Our groove mounting plates are designed to complement the the 12mm groovemount found on all our V6 and V6 Lite hotends, allowing easy assembly of a hotend into a printer. The plate should be attached to a printer's carriage with screws or bolts, the groovemount section of the heatsink can they be pressed into the plate by hand, thus rigidly clamping the hotend in place. The mounting plates are made from precision machined POM, a very wear resistant plastic, so the hotend can be taken out any refitted multiple times without causing any harm to the mounting plate.
 +
 +
 +
Engineering drawing:
 
[[File:Groove_Mounting_Plates.pdf]]
 
[[File:Groove_Mounting_Plates.pdf]]
 +
 +
Link to shop page:
 +
[http://e3d-online.com/v6-Groove-Mounting-Plate?search=groove V6 Groove Mounting Plate]

Revision as of 14:27, 3 January 2017

Grove Mounting Plates

File:Groove Mounting Plates.png
E3D Groove Mounting Plate

Our groove mounting plates are designed to complement the the 12mm groovemount found on all our V6 and V6 Lite hotends, allowing easy assembly of a hotend into a printer. The plate should be attached to a printer's carriage with screws or bolts, the groovemount section of the heatsink can they be pressed into the plate by hand, thus rigidly clamping the hotend in place. The mounting plates are made from precision machined POM, a very wear resistant plastic, so the hotend can be taken out any refitted multiple times without causing any harm to the mounting plate.


Engineering drawing: File:Groove Mounting Plates.pdf

Link to shop page: V6 Groove Mounting Plate