Non-Titan Idler Arms
From E3D-Online
This Wiki is not looked after anymore :( Please navigate to
e3d-online.dozuki.com
for up to date and improved documentation
e3d-online.dozuki.com
for up to date and improved documentation
If you are building a Titan BigBox you can skip this step.
Part-thread the M4 12mm grub screw through the idler arms, carefully feeding on the 604-ZZ (4mm ID x 12mm OD x 4mm W) bearing and washer before tightening (washer-bearing-washer).
Note : The grub screw is 2mm shorter than the thickness of the idler. Take care to center it in the part.
Note : The 604zz Bearing(s) are in the Extruder Box.
If you are building a Titan BigBox you can skip this step.
This is the updated Hybrid Idler.
Note : The 604zz Bearing(s) are in with the Printed Parts.